How to make your voice sit clearly over background music

When a voice gets lost under music, it's rarely because the music is too loud overall. Music and speech share the same frequencies, especially the 1 to 4 kHz range where words become clear. This guide gives you starting points for three things that fix that: EQ (carve a pocket in the music for the voice), levels (how far under the voice the music sits) and ducking (the music dips when you speak).

The voice pocket

Instead of turning the whole music track down until it disappears, cut the music gently where the voice is clearest. A wide 2 to 4 dB dip around 2 to 3 kHz is usually enough. The music keeps its warmth and space, and the voice has a place to sit. Clean up the voice too: a high-pass filter removes rumble, a small cut clears boxiness, and a gentle lift adds clarity.

How loud should background music be under a voice?

As a starting point, around 20 to 24 dB below the voice for guided meditation, a little less for podcasts and video. Measure it while you're speaking, not in the gaps. If you have to strain to hear a word on earbuds, the music is too loud.

What loudness should I export at?

Apple Podcasts asks for about -16 LUFS integrated with a true peak at or below -1 dBFS. YouTube doesn't publish a number but is widely measured at -14 LUFS. Audible (ACX) uses different measurements: RMS between -23 and -18 dB, peaks at or below -3 dB and a noise floor at or below -60 dB. The guide links each source.

Deeper and lighter voices

Deeper voices have more energy low down, so they need a lower high-pass and benefit from a little space in the music around 200 Hz. Lighter voices sit higher, so their clarity range and their sibilance are a little higher too. Pick the one that sounds like you; it's about your voice, not who you are.

Every number here is a starting point. Trust your ears, check on earbuds and a phone speaker, and keep the music in service of the voice.